For 1990-2009 cars only
- Install the spacer plate locating pins (401) into the control valve body assembly (250).
- Install the regulator body spacer plate (400).
- Lubricate and install a new stator shaft O-ring seal (406) on the stator shaft and torque arm assembly (431).
- Install the stator shaft and torque arm assembly (431) through the hole located in the control valve body assembly (250). Ensure that the assembly is fully seated and moves freely.
- Insert the 7 x 71 mm stator shaft stop pin (405) into the hole located in the control valve body assembly (250).
- Install the regulator valve body assembly (430) onto the control valve body assembly.
- Install the following regulator valve body bolts:
- Tighten the bolts in the sequence shown.
| • | Ensure that the pin bottoms out in the hole located in the torque converter housing assembly (150). |
| • | Position the torque arm assembly to allow the pin to be positioned between the stops. |
| • | 2 M6 x 1.0 x 35 mm bolts (411) |
| • | A M6 x 1.0 x 55 mm bolt (412) |
| • | 4 M6 x 1.0 x 70 mm bolts (413) |
| • | A M6 x 1.0 x 80 mm bolt (414) |
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten all bolts to 12 N·m (106 lb in).
