GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Saturn 🢒 2006 🢒 VUE - FWD 🢒 Transmission/Transaxle 🢒 Automatic Transmission - 5AT 🢒 Reverse Idler Gear Replacement

Removal Procedure

    Object Number: 1542296 Size: SH
  1. Remove the 2 reverse idler gear retaining plate bolts (532) from the transmission case (31).
  2. Remove the reverse idler gear assembly (533) from the transmission case (31).
  3. Remove the 2 reverse idler gear locating pins (530) from the transmission case (31).

Disassembly Procedure

    Object Number: 1542303 Size: SH
  1. Remove the reverse idler gear retaining ring (525).
  2. Remove the following components from the reverse idler gear returning plate assembly (531):
    3. • The reverse idler gear thrust washer (526).
    • The reverse idler gear (527).
    • Both reverse idler gear inner bearings (528).
    • The lower reverse idler gear thrust washer (526).

Inspection Procedure

    Object Number: 1542294 Size: SH
  1. Inspect all components for excessive wear or damage. Replace as needed.
  2. Inspect the bearings for wear or damage. Replace as needed.

Assembly Procedure

    Object Number: 1542295 Size: SH
  1. Install the lower reverse idler gear thrust washer (526) on the reverse idler gear retaining plate assembly (531).
  2. Install the 2 reverse idler gear inner bearings (528) on the reverse idler gear retaining plate assembly (531).

    3. Important: The shorter hub side of the reverse idler gear installs to the plate as shown.

  3. Install the reverse idler gear (527) on the reverse idler gear retaining plate assembly (531).
  4. Install the upper reverse idler gear thrust washer (526) on the reverse idler gear retaining plate assembly (531).
  5. Install the reverse idler gear retaining ring (525) on the reverse idler gear retaining plate assembly (531).

Installation Procedure

    Object Number: 1542296 Size: SH
  1. Install both 10 x 16 mm reverse idler gear locating pins (530) into the transmission case (31).

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the reverse idler gear assembly (533) into the transmission case (31).

    3. Important: Overtightening of the idler gear retaining plate bolts will cause the reverse idler gear to bind.

  3. Install both M8 x 1.0 x 35 mm reverse idler gear retaining plate bolts (532).

    4. Tighten
    Tighten the bolts to 26 N·m (20 lb ft)