- Install the following components into the
torque converter housing (150):
| • | The 1st/2nd clutch housing thrust bearing (750) with the rounded
shoulder down |
| • | The 1st, 2nd clutch shaft assembly (755) |
| • | Both torque converter housing locating pins |
| • | The torque converter housing gasket (68) |
- Measure the height (a) of the 1st/2nd
clutch shaft assembly (755) from the top of the torque converter housing gasket (68)
to the top of the 1st/2nd clutch shaft bearing (719).
- Record the measurement. The measurement is the recorded 1st/2nd clutch
shaft installed height.
- Use the following formula for selection of the correct thickness of the
1st/2nd clutch shaft shim (74):
Formula
The recorded 1st/2nd clutch shaft installed height
measurement minus the 1st/2nd clutch shaft installed height specification equals the
required shim thickness adjustment.
Specifications
1st/2nd clutch shaft installed height 222.54-222.63 mm
(8.761-8.765 in)
- Remove the 1st/2nd clutch shaft shim (74)
from the transmission case (31).
- Measure the thickness of the shim.
| • | In the above formula if the recorded height was less than the specification
height, add the difference to the removed shim (74). |
| • | In the above formula if the recorded height was more than the specification
height, subtract the difference from the removed shim (74). |
- If the thickness of the shim is not the required thickness from the above
formula, select from the table the correct thickness of shim. Refer to
Shim Size Specifications
.
- Install the correct 1st/2nd clutch shaft 65 mm selective shim (74)
into the transmission case (31).
