Was the Wiper/Washer System Check performed?

--

Go to Step 2

Go to Wiper/Washer System Check

1. Set ignition switch to ON.
2. Set the wiper switch to LO.
3. Disconnect wiper motor connector C1.
4. Connect a test light from connector C1 terminal F, to ground.
5. Momentarily activate the washer switch while observing the test light.

Is the test light on after the washer switch is released?

--

Go to Step 4

Go to Step 3

Replace the wiper motor cover. Refer to Wiper Motor Cover Replacement .

Is the replacement complete?

--

Go to Wiper/Washer System Check

--

Replace the wiper/washer switch. Refer to Multifunction Turn Signal Lever Replacement - On Vehicle .

Is the replacement complete?

--

Go to Wiper/Washer System Check

--