1

1. Turn the ignition switch to ACCY or ON.
2. Hold the washer switch in the ON position for 1-2 seconds.

The washer sprays the windshield until the switch is released. The wipers run at low speed and continue to run for approximately 6 seconds after the wash cycle is complete, then return to the park position.

2

1. Turn the wiper switch to DELAY (pulse mode).
2. Activate the delay time by turning the wiper switch.

The wipers make one complete sweep, then pause for 0-25 seconds before making the next sweep. The pause time is adjusted by turning the wiper switch through the delay range.

3

1. Turn the wiper switch to DELAY.
2. Hold the washer switch ON for 1-2 seconds.

The washer sprays as long as the washer switch is held ON. The wipers run at low speed during the spray period and continue for approximately 6 seconds after the spray cycle. The wipers then return to pulse operation.

4

Turn the wiper switch to LO.

The wipers run continuously at low speed.

5

Turn the wiper switch to HI.

The wipers run continuously at high speed.

6

Turn the wiper switch to OFF.

The wipers return to the park position at low speed.

7

Turn the wiper switch to MIST, then release.

The wipers make one complete sweep at low speed and park.

* Refer to the appropriate symptom diagnostic table for the applicable abnormal result.