1. Turn the ignition switch to the ON position.
2. Make sure radio is OFF.

The radio displays the current time.

Turn the radio ON.

The radio displays the current station for approximately 5 seconds and then the current time.

Turn the headlamp switch to the PARK position.

Interior Lights Dimming System Check

1. Turn the FADE control to the front speakers.
2. Turn the balance control to the left front and then to the right front speaker.

1. Turn the FADE control to the rear speakers.
2. Turn the balance control to the left rear and then to the right rear speaker. Return the fade and balance control to the neutral position.

Ppress the RECALL button.

The radio display toggles between the tuner and the clock.

The radio control is inoperative Refer to:

Adjust BASS control to the high and low position.

The music attenuates between high and low bass frequencies.

The radio control is inoperative Refer to:

Adjust TREB control to the high and low position.

The music attenuates between high and low treble frequencies.

The radio control is inoperative Refer to:

Return BASS and TREB control buttons to the neutral position.

The music returns to nominal bass and treble frequencies.

The radio control is inoperative Refer to:

Press the AUTO TONE button seven times.

The auto tone cycles through the following presets:

The radio control is inoperative Refer to:

Press the BAND button up to access the FM1 and FM2 bands.

The radio stations on the FM1 and FM2 bands appear on the display.

The radio control is inoperative Refer to:

Press the BAND button down to access the AM band.

The radio stations on the AM band appear on the display.

The radio control is inoperative Refer to:

Press and hold the SCAN button for 2-3 seconds.

Each of the presets are scanned for a few seconds and continues until the button is pressed again.

The radio control is inoperative Refer to:

Press and hold HR or MIN until the time display begins to change.

The time display begins to move, after an approximately a 2 second delay.

The radio control is inoperative Refer to:

Insert a known good cassette tape into the tape player.

The cassette tape plays and sound is heard from the speakers.

Tape Player Weak, Slow, or Garbled Output

The tape player is inoperative. Refer to:

The tape player control is inoperative. Refer to:

Press the FWD button.

The cassette tape will fast forward and then reverse.

The tape player control is inoperative. Refer to:

Press the REV button.

The cassette tape will reverse.

The tape player control is inoperative. Refer to:

Press the AM/FM button.

The sound toggles from the cassette tape player to the radio tuner.

The tape player control is inoperative. Refer to:

Press the EJECT button.

The cassette tape player will eject tape.

The tape player control is inoperative. Refer to:

Insert a known compact disc (CD) into the CD player (w/signal disc CD player).

The CD plays and sound is heard from the speakers.

The CD player is inoperative Refer to:

Press the TUNE-SEEK button.

The CD moves to next selection and plays.

The CD player control is inoperative. Refer to:

The CD player control is inoperative. Refer to:

1. Insert a known compact disc (CD) into the CD player (w/12-disc CD player).
2. Press the SOURCE button.

The CD plays and sound is heard from the speakers.

* Refer to the appropriate symptom diagnostic table.